Ingredients for 5 Gallons:

• 1 Can hopped malt extract
• 1 Packet yeast
• 2 lbs. dry malt extract or corn sugar
• 3/4 - 1 Cup priming sugar

Optional:

• 1/3 oz. Burton Water Salts
• 1 oz. Boiling hop pellets
• 1 oz. Finishing hop pellets
• 1 tsp. Irish Moss

Thoroughly clean and sanitize anything that will come in contact with the fermenting beer, except bottles and caps which will be sanitized just prior to bottling.

Let the malt can stand in warm water for 15 - 20 minutes to make it easier to remove it from the can. Empty the dry malt or corn sugar into a large stainless steel or enamel pot (sufficient to hold 2+ gallons). Open the can of malt and empty the contents into the pot with the dry malt or corn sugar. Using at least 1 gallon of hot water, rinse out the can and add this to the pot. Turn on the heat and bring to a boil slowly, stirring constantly in order to avoid scorching the ingredients. If you are going to use Burton Water Salts to harden the water, add the contents of the package at this point. While you are waiting for the wort to boil, place 3 gallons of cold water into the primary fermenter. You want to end up with a total of 5 gallons. So, if you boil 4 gallons, only add 1 gallon to the fermenter.

Once the wort has started to boil, if you are going to use Boiling hops, add the Boiling hops and continue to boil for 20 minutes while stirring and watching for boil over. If you are going to use Finishing hops, add the Finishing hops and boil for 10 more minutes. If you are going to use Irish Moss to clarify the beer, add it during the last 10 minutes of the boil. If you are not using hops or Burton Water Salts, boil the wort for at least 30 minutes.

When you are done with this process, cool the hot wort and transfer into the primary fermenter. Top off to the 5-gallon level and cover to prevent contamination and wait for the temperature to reach 70 degrees F. Take a hydrometer reading and note the results.

Add the yeast to 1 1/2 cups of warm (not hot) water and allow it to become active (approx. 10 minutes), then add it to the wort.

Place the blow off hose into the lid and allow it to hang down into a jar that contains enough water to cover the bottom of the blow off. Allow the beer to ferment for 2 days in the primary fermenter, then siphon it into the secondary fermenter. Fill the airlock 1/2 full with water or vodka and place it in the secondary fermenter. Allow the beer to ferment for an additional 5 to 14 days. Use your hydrometer to check the specific gravity. Fermentation is complete when the specific gravity remains the same for 2 consecutive days.

Once again: sanitize all of the equipment that comes in contact with your beer, including the caps.

Dissolve the sugar in a cup of water by bringing it to a boil. Then pour it into the bottling bucket. Siphon the beer from the secondary fermenter into the bottling bucket. Fill and cap the bottles. Let the beer stand at room temperature for 3 - 5 days, then move to a cooler area for 3 to 4 weeks (the hardest part, but worth the wait).

If you don't have a secondary fermenter, don't worry, the beer will be just fine. You may wish to use the blow off tube for the first few days, then place the airlock on the primary fermenter.

Please call us any time if you have questions, would like assistance or would like to place an order.

Enjoy, and keep brewing.

Ó 1999 Kahn Business Systems www.kahnnet.com contact us @ gofbhsc@li.net